MKS BASE V1.5 USB Compatible with Mega 2560 R3 Mainboard + Ramps 1.2

Beskrivelse

MKS BASE V1.5 USB Mega 2560 R3 Motherboard MKS Base V1.5 is the combination of Arduino MEGA2560 plus RAMPS1.4 and A4982 in 3D printer . It is a feature rich all-in-one electronics solution for Reprap and other CNC devices. It features an onboard ATmega2560. Its five motor outputs are powered by A4982 stepper drivers. It use FTDI FT232R device for USB and not ATMEGA16U2 as ARDUINO MEGA2560. The board can use the same firmware as Ramps1.4. MKS Base V1.5 is designed to be flexible in the user's power source availability, allowing any power supply from 12V-24V. It is supplied with a Marlin firmware. Of course you can also upload another firmware. You can use Arduino IDE to upload firmware to MKS Base V1.5 board through ICSP PIN. While uploading the blue LED is lit and the RX/TX LEDs will blink fast. Features: This is the combination for Arduino MEGA2560 + RAMPS1.4 + 5 x A4982 drivers (remix board) Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware Firmware can use the same configuration as RAMPS1.4 It is suitable for dual-Extrude printer Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board 3x temperature ADC connectors for thermistors Up to 5 motor drivers with A4982 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed, Extruder0, Extruder1, Fans) 4 layers PCB, optimize heat dissipation. 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax Recoverable fuse for short-circuit protection. USB Driver Chip FT232RL, you can get files from ftdichip to setup driver: Ftdi-x86.zip Fireware: This section will show you how to get firmware into your controller and run it with basic settings. Software required: FTDI USB drivers, for Arduino IDE, Choice of firmware (Marlin or Repetier or Sprinter), Pronterface USB VCP Drivers - MKS Base uses the newer FT232 USB to UART chip and it needs the updated VCP(virtual com port) drivers from the manufacturer's